View previous topic :: View next topic |
Author |
Message |
Lee Guest
|
Posted: Fri Aug 05, 2005 11:48 pm Post subject: |
|
|
Re: Butterflying
We butterfly turkeys at our house, then cook on the gas grill. I saw the technique on a PBS show, but they cooked their bird in the oven. When the bird is brined first and cooked pretty fast, this yields the juiciest turkey. |
|
Back to top |
|
|
Lisa Guest
|
Posted: Fri Aug 05, 2005 11:48 pm Post subject: |
|
|
Thank you! I've always wondered how this is properly done. |
|
Back to top |
|
|
an anonymous reader Guest
|
Posted: Fri Aug 05, 2005 11:48 pm Post subject: |
|
|
On one of his shows, I saw Martin Yan cut up a chicken. He said he would do it in under a minute; he came in closer to twenty seconds. |
|
Back to top |
|
|
perrine Guest
|
Posted: Fri Aug 05, 2005 11:49 pm Post subject: |
|
|
Hi,
It is perfect since I always struggle against thighs... However, is it the same technic when the chicken is roasted? Thanks a lot!!! |
|
Back to top |
|
|
Michael Chu
Joined: 10 May 2005 Posts: 1654 Location: Austin, TX (USA)
|
Posted: Fri Aug 05, 2005 11:49 pm Post subject: |
|
|
re: carving a roast chicken
The technique is similar, but you deal with the breast a little differently. I have a pictoral attached tot he bottom of the Classic Roast Turkey recipe at
http://www.cookingforengineers.com/article.php?id=74 |
|
Back to top |
|
|
vinal Guest
|
Posted: Fri Aug 05, 2005 11:50 pm Post subject: |
|
|
As an engineer, the presentation couldn't be better, it was well done and straight to the point.
Is there a specific name for the knife shown, as in deboning knife ?
Want to get a good reputable knife. Any suggestions ?
Thanks |
|
Back to top |
|
|
Michael Chu
Joined: 10 May 2005 Posts: 1654 Location: Austin, TX (USA)
|
Posted: Fri Aug 05, 2005 11:50 pm Post subject: |
|
|
re: knife used
The knife used in this pictoral is an 8 in. Chef's knife. I chose this knife because I was able to effectively work dextrously with it while still having the ability to push through bones when I needed to. A boning knife would give you a great deal more control, but is not useful when trying to cut through the keel bone.
We'll use a boning knife for preparing a boneless chicken.
I've added some comments to the article on what instruments were used in this procedure. |
|
Back to top |
|
|
Kim from York Guest
|
Posted: Fri Aug 05, 2005 11:51 pm Post subject: |
|
|
Great Site however Meats should always be carved, cut, dressed,on plastic or something less porus than wood. Bacteria has a tendency to to get trapped in the cuts on the wood not easily cleaned out. |
|
Back to top |
|
|
Michael Chu
Joined: 10 May 2005 Posts: 1654 Location: Austin, TX (USA)
|
Posted: Fri Aug 05, 2005 11:52 pm Post subject: |
|
|
re: wood vs. plastic cutting boards
As I mentioned in the Cutting Boards article, wood butting boards do not harbor bacteria. In fact, most kitchens have cleaner wood cutting baords than plastic because home chef's do not replace their plastic cutting boards often enough.
Conventional wisdom states that because you cut grooves into wood cutting boards, bacteria can be trapped in those micro-grooves allowing rampant growth of germs. This is true, but a thorough scrubbing will clean out all large particles and as the wood dries, the wood naturally becomes a hostile environment killing any surface bacteria and drawing the rest deep into the board (away from the surface).
Plastic boards on the other hand will develop small grooves from cuts and these won't "heal" (soften to form a continuous surface). The bacteria is much harder to get out even with severe scrubbing. Plastic cutting boards that have touched meast or poultry should go through a dishwasher cycle to heat kill the bacteria since washing and drying does not have the germicidal effect of wood boards. Also, once the board has developed too many grooves, the board should be replaced.
Link to Equipment & Gear: Cutting Boards |
|
Back to top |
|
|
Alderete Guest
|
Posted: Fri Aug 05, 2005 11:53 pm Post subject: |
|
|
Regarding Martin Yan's speedy chicken processing. I read where he and Jacques Pepin have speed competitions for deboning chickens, when they get together on PBS shows and such.
Martin uses a Chinese cleaver, Jacques uses a chef's knife. They both go like lightening.
It's probably scary to watch, as well as a amazing. Shows what just a little practice will get you... |
|
Back to top |
|
|
an anonymous reader Guest
|
Posted: Fri Aug 05, 2005 11:53 pm Post subject: |
|
|
...where the thigh bone meets the drumstick, one can easly see a line of fat that marks the angle to cut. Nature shows the way! |
|
Back to top |
|
|
an anonymous reader Guest
|
Posted: Fri Aug 05, 2005 11:54 pm Post subject: |
|
|
There's an easy way to find the thigh joint. First cut the skin and fleshy bits on the frontal groin portion of the chicken between the leg and the breast. Next, push back the thigh into a good ballet-style turnout, keep pushing the "knee" backwards towards the chicken's back and the thighbone will *pop* right out of the pelvic joint. It's easy to then just cut through the little bit of soft fleshy material in the joint. |
|
Back to top |
|
|
Connie Guest
|
Posted: Fri Aug 05, 2005 11:55 pm Post subject: |
|
|
I was looking for a roasted potato technique and found your site. (After 25 years of cooking for my family I have found a difference between cooking techniques and recipes.)
RE: cutting up chicken...if your look carefully at the joints you will see a fine line of fat which appears as a thin white strip under the skin. Cut through this line of fat and you hit the joint each time. It's visible on every joint you cut. |
|
Back to top |
|
|
sidoc Guest
|
Posted: Tue Aug 23, 2005 1:01 pm Post subject: site |
|
|
Just wanted to thank you for a great site: well laid out, clear rationale (eg, use of salt water in marinade for chicken), helpful pics. I'll try to post the outcome of the chile lime grilled chicken! B |
|
Back to top |
|
|
Guest
|
Posted: Wed Sep 07, 2005 1:56 am Post subject: Cutting chickleg joint |
|
|
Back in the poor student stage, this was the way I came up with.
I grap the chick leg with my left hand and the rest of the chicken by my right hand so that my thumbs towards each other (almost like vectors). I can easily determine where the joint based on the way the legs can rotate. The place where my two thumbs eventually lined up where there is a slight depression between. There's where I make my cut. |
|
Back to top |
|
|
|